![]() Pressure, on the other hand, acts in all directions and is addressed in PSI (pounds per square inch). That force acts in one direction and is addressed in pounds. This pressure is a totally different thing than the force you apply to the pedal. ![]() There’s something else to think about: brake line pressure. In order to arrive at the pressure required, changing the overall length of the pedal is possible, although it’s probably a bunch easier and usually far more practical to simply shorten the distance between the pivot point and the master cylinder pushrod mount location. That’s how fab shops modify brake pedals. This is accomplished by way of a lever (the brake pedal). You have to figure out how to transform the 100 or so pounds of relaxed leg pressure (roughly one-third of the 300 PSI as we mentioned above) into pretty big PSI figures. A typical manual master cylinder usually requires something in the range of 600 to 1000 PSI to function properly. Let’s look at how all this applies to activating your master cylinder. That’s a whole bunch! Something in the order of one-third or one-half that figure is certainly more relaxed, even in a bad-to-the bone hot rod. The force is measured as pounds per square inch (PSI), and we’re told that the average adult male can exert roughly 300 pounds of force (maximum) with one leg. The formula essentially figures out the amount of force exerted by you through your leg times the pedal ratio divided by the area of the brake piston(s). This is the mechanical advantage of the lever or in simpler terms, the “pedal ratio.” There is a mathematical equation that helps you figure it out: Input Force X Pedal Ratio / Brake Piston Area = PSI If the length of the pedal or the distance between the pushrod mount–or a combination of both–is changed, then there is a change in the amount of (leg) force required to energize the brake master cylinder. You’ll find that the pivot point (where the pedal swivels) and the mounting point for the master cylinder pushrod are often rather different. The master cylinder, in turn, forces fluid to the disc brake caliper pistons or drum brake wheel cylinders. The brake pedal acts as a lever to increase the force the driver applies to the master cylinder. When it comes to reworking the brakes on your car, two things seldom come into consideration: your master cylinder and pedal ratio. And those are two factors that are absolutely critical to your brake system performance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |